To do that you need to get into the studs.
Should be mounted on wall studs rack.
Run the stud finder along the wall in the approximate area where you plan to mount your television.
This mount goes in over a concrete or masonry wall using anchors and plasterboard or drywall if drilling directly into wall studs.
You can also find some that run horizontally.
Finding studs inside of your wall can sometimes be a tricky proposition but luckily there are a few.
Position the wall mounted bike rack so that the wheels of the.
Ceiling racks should only be mounted in a joist.
If the rack is too short to intersect two studs you have two options.
The most secure way to hang a coat hook wine rack picture or any piece of wall art is to attach a screw to a stud.
Test fit the pot rack on the wall where you want to install it.
To more accurately find the edges of the studs since you ll need to find the precise center later on use a small drill bit to explore behind the drywall.
If possible plan to hang the rack so it will be securely attached to the wall studs.
Or you can attach one side of the coat rack to a stud and use a wall anchor to attach the other side.
You want to anchor your bike rack into the studs rather than the drywall to hold the weight of the rack and your bikes.
Most structures have vertical studs spaced 16 inches apart.
For regular drywall use a stud finder to locate the studs inside the wall.
Secure the structure to wall studs if available for maximum security no matter how many heavy coats hang from the rack.
Choose anchors rated for heavy loads to ensure the rack stays put even under a load.
If the rack is mounted by a single bolt locate it on top a stud.
The wall section is very short so there may be a stud in the middle but more likely just at the ends.
If a stud is not available install at least two sturdy wall anchors or more if the rack is more than 2 feet long.
When possible you should always mount your rack by screwing into your wall s studs.
I would do the following.
Mark the left and right edges with a pencil in several spots along the vertical plane.
Studs are the vertical wood supports inside of your walls that provide structural support for your home and a place to hang your drywall.
If the rack has multiple bolts place at least one of these on the stud.
When you have a stud.
Cut a short piece of wood e g 1 x 4 length cut to fit between the tile and the doorway.
Pass the tip of a pencil through the screw holes on the rack to faintly mark their positions on the wall.
Studs are pieces of wood beneath the drywall that act as the wall s frame.
Remove the other end of the towel bar.
If this is not possible cut a piece of 3 4 plywood that can be anchored to the wall studs.